SWEVEN IoT – Alarm Wiring Instructions

1. Overview
   The alarm system integrates with the Sweven IoT sensor box using an aviation-type connector.
   Both devices use a GX16 8-pin connector and are linked with a custom cable (see Image 1).
   This guide outlines the specifications, wiring instructions, and usage procedures for proper
   installation and operation.

2. Connector & Cable Specifications
   Connector Type
   Connector sample: https://a.co/d/e6Talvk
   ● Model: GX16 8-Pin Aviation Connector (Female Set)
   ● Number of Poles: 8
   ● Voltage Rating: 125V AC (stated); Max Voltage (AC/DC): 380V
   ● Current Rating: 5A
   Cable Specifications
   Cable sample: https://a.co/d/9nEhPck
   Sweven
   ● Wire Gauge: 22 AWG, 6 conductors
   ● Colors: Red, Black, Yellow, White, Green, Orange
   ● Material: Tinned copper (34 strands of 0.16 mm per conductor)
   ● Insulation: PVC
   ● Outer Diameter: ~7.62 mm (0.3 inch)
   ● Length: 30 meters (100 ft)
   ● Voltage Rating: 300V
   ● Current Rating: 7.5A
   ● Operating Temperature: Up to 80°C (176°F)

3. Wiring Instructions
   The 6 wires should be connected to the GX16 connector following the specified pin
   configuration (see Image 3). Proper soldering is required to ensure electrical contact and
   mechanical stability.

● Use heat shrink tubing over each connection to protect against short circuits and
improve durability.
● If the alarm unit is frequently handled or subject to vibration, additional strain relief using
heat shrink tubing is highly recommended (see Image 4 and Image 5).

4. Alarm Operation
   Before using the alarm system, ensure that the Sweven IoT sensor box is powered on and
   properly functioning.
   White Button – Test Mode
   ● This is a test button used to validate system readiness.
   ● Press and hold for 1 second to activate test mode.
   ● The alarm buzzer and LED will blink briefly, confirming functionality (see Image 6).
   ● This is a functional test only. It does not indicate an actual alarm condition
   Sweven
   Red Button – Alarm Activation
   ● The red button illuminates and the buzzer activates when oil level sensors detect 70%
   or more of tank capacity.
   ● The buzzer sounds for 30 seconds or until a user presses and holds the red button for 1
   second.
   ● The red light remains on until the oil level drops below 65% of tank capacity.